Operating Sequence - Electrolux EWF1495 Instruction Booklet

usermanual 1495 au_5.qxp 11/6/2006

Operating sequence

Before the first wash we recommend that you pour 2
litres of water into the main wash compartment
of the detergent drawer. Then run a cotton cycle at
60°C, with the machine empty, in order to remove
any manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment
If you wish to carry out the prewash or soak phase,
pour detergent into the appropriate compartment
marked .
3. Measure out the additive
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
5:53 PM Page 17
4. Switch the machine ON
Turn the selector dial to the desired programme to
switch the appliance on.
To switch the appliance off turn it to «Off».
Switching the appliance for the first time.
LANGUAGE
When switching on the appliance for the first time
you must set the language in which you want the
indicators in the display to appear.
Important!
If the display is not showing any language, the
appliance has already been switched on once. In
such case, go to the chapter «Change language» if
you would like to change the language setting.
.
17