Fast Warm Up R; Using The Automatic Function - Electrolux COMPETENCE E 8100 Operating Instructions Manual

Fast Warm Up R

Following selection of an oven function, the empty oven can be
pre-heated in a relatively short period of time using the function
"Fast Warm Up".
Important: Please only place the food to be cooked in the oven when
1
fast warm up is complete and the oven is running in the required func-
tion.
1. Set the required oven function (e.g. CONVENTIONAL). Change the sug-
0
gested temperature if necessary.
2. Press the fast warm up button R.
The indicator above the fast warm up button illuminates. Fast warm up
starts.
When the temperature set is reached, an acoustic signal sounds. The
indicator extinguishes.
The oven is now kept hot using the pre-set oven function and tempera-
ture. You can now put the food to be cooked in the oven.
The fast warm up function cannot be used with the grill, bottom heat
3
or defrost functions.
Please see the "Usage, Tables and Tips" section for recommendations on
fast warm up.

Using the Automatic Function

There are two possible ways of using the automatic function:
• Automatic switch-off: If you have switched on the oven and simply
do not want to forget to switch off the oven at the right time, you
can define either the duration or the end of the cooking time with
the clock. The oven then switches itself off automatically.
• Automatic Switching On and Off: When you, for example, in the
morning or at lunch time want to prepare a dish for the evening, you
can set the cook time and also the end time. The oven then switches
on automatically at the calculated start time, and switches off again
automatically at the end of the cooking time.
– Example: The roast requires cooking for 1 hour: COOK TIME = 1.00.
The roast is to be ready at 18:00: END TIME = 18.00.
The oven function can be selected either before or after setting the
automatic function.
You have approx. 5 seconds to make an entry after the selection of a
3
clock function. At the end of this time, the function indicator for the
selected clock function goes out and you must select it again.
Operating Instructions
25