Tcp/Iq Setup; Tcp/Iq Addressing Worksheet - Crown I-T4000 Operation Manual

4 Advanced Operation

4.5.6 TCP/IQ Setup

This example is based on a stand-alone system using switches and routers. The screen
captures were done in Windows 2000; your exact configuration may vary. If your computer
uses a network for other applications, please check with your Information Technology
Department before making any changes. Section 4.5.7 includes a helpful worksheet for
assigning addresses.

4.5.7 TCP/IQ Addressing Worksheet

Table 4 is an example of valid TCP/IP addresses on a stand-alone network. If the TCP/IQ
network is going to be shared with other people, check with the Network Administrator for
their addressing scheme. Without getting into all of the networking rules, the table lists
approximately 20 network addresses out of a possible 65,534 addresses on this network.
There are other addresses that are valid; these are just shown as a starting point.
• The Subnet Mask for all components, including the computer, needs to be set to
255.255.0.0.
• Each computer running IQwic software must have a subnet mask of 255.255.0.0. It also
must be assigned one of the addresses listed on the following table.
• A space has been left to the right of all the addresses. This area is for your notes, such as
the IQ address or the component type.
In the CD-ROM that came with your I-Tech amplifier is an Excel spreadsheet that you can
use to keep track of TCP/IQ addresses.
page 28
Table 4
EXAMPLE OF AN IQ ADDRESSING WORKSHEET
ADDRESS IQ ADDRESS MODEL DESCRIPTION
126.126.0.1 COMPUTER
126.126.0.2 2 I-T8000 #1 RACK ROOM
126.126.0.3
126.126.0.4
126.126.0.5
126.126.0.6
126.126.0.7
126.126.0.8
126.126.0.9
126.126.0.10
126.126.0.11
126.126.0.12
126.126.0.13
126.126.0.14
126.126.0.15
126.126.0.16
126.126.0.17
126.126.0.18
126.126.0.19
126.126.0.20
I-Tech Series Power Amplifiers
CHANNEL 1 CHANNEL 2
LEFT CLUSTER RIGHT CLUSTER
Operation Manual