Table of Contents
Advertisement
Connecting with Wireless LAN (continued)
Computer operation
1
Make the network setting according to your system administrator.
If the projector settings are the default settings (See page 15), then the computer can be used with the
following network settings.
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
2
Click [Start]→[Connect To
network of [SSID] set with the projector, and then click [Connect
If the projector setting is the factory setting, then [SSID] is [Panasonic Projector].
The names are for Windows XP. In Windows Vista/Windows 7, the procedure will be [Start]→[Connect To].
_
Note
・
If you use any wireless utility other than Windows [Wireless Network Connection], follow its operation
procedure for connection.
・
If you use the access point, configure the projector and each network setting of the computer following
the instruction of the network administrator.
192.168.11.101
255.255.255.0
192.168.11.1
]→[Wireless Network Connection
_
20
], select the wireless
_
].
_
Advertisement
Table of Contents
