Table of Contents
Advertisement
Problem
The corresponding display
does not light up when one of
the additional program but-
tons is pressed.
The program sequence indica-
tor flashes constantly.
If the washing result is not satisfactory
If the washing is grey and limescale
forms in the drum
• Not enough washing detergent added.
• The right washing detergent was not used.
• Special types of stain were not pretreated.
• Program or temperature incorrectly set.
• If binary wahing detergents were used, the indi-
vidual components were not added in the correct
ratio.
If there are still grey stains on the wash-
ing
• Washing contaminated with creams, grease or
oils was washing with too little detergent.
• Washing at too low temperature.
• A frequent cause is that conditioner – particularly
concentrated form, ended up on the washing.
Wash out such stains as quickly as possible and
carefully use the right conditioner.
28
Possible Cause
The selected additional program can-
not be combined with the set pro-
gram.
Program saving function switched on;
The program selector was acciden-
tally readjusted during the washing
cycle.
Make another selection.
Turn the program selector back to its
original position (see "Program
saving").
If foam is still visible after the final rinse
• Modern washing detergents can still produce
foam, even in the final rinse. The washing is still
sufficiently rinsed.
If there are white residues on the wash-
ing
• These are the insoluble components of modern
detergents. They are not the result of an insuffi-
cient rinsing effect.
Shake or brush off the washing. Perhaps in future
you should turn the washing before washing it.
Check the choice of detergent and use a liquid
detergent if necessary.
Remedy
Advertisement
Table of Contents
