Preparing Your Appliance For Installation
Read all instructions before beginning your installation. If instructions
have not been read carefully, your installation could void your warranty
and may create a serious fire, health, or other safety hazard.
The Lennox Hearth Products warranty will be voided if one of the fol
lowing occurs:
• Installation of any damaged stove or vent system component.
• Unauthorized modification of the directvent system.
• Installation other than as instructed by Lennox Hearth Products,
Security Chimneys™, or Simpson DuraVent.
• Installation of any stove or vent system component not manufac
tured or approved by Lennox Hearth Products, Security Chimneys™,
or Simpson DuraVent.
When planning the installation for your appliance, it's necessary to
consider the following:
• Where the unit is to be installed
• The vent system configuration to be used
• Gas supply (NG or LP)
• Electrical wiring
• Optional accessories (door trim/grill assembly and wallmounted
or remote thermostat)
Rear Vent Dimensions
Figure 1
Dimensions
The gas line attaches to the gas valve at the back of the stove 21/2" in
from the left side of the stove and 81/2" up from the base of the unit.
Test all gas connections for leaks with a gas leak test solution.
Figure 2
Flue Collar
28"
(711mm)
24-3/4"
(629mm)
Figure 3
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Top View
Front View
18-1/2"
(470mm)
14-7/8"
(378mm)
32-1/2"
(826mm)
9