Installation; Installing Door Trim And Spring Handle - Lennox Hearth Products VISION Elite SDVSS-25 Installation And Operation Manual

INSTALLATION

Installing Door Trim And Spring Handle

CAUTION: Always ensure that plated surfaces are clean and
free of fingerprints before lighting stove. Fingerprints will leave
permanent blemishes if left on plated surface when lit. When
installation is complete, the trim should be gently cleaned
with a soft cloth and either alcohol or glass cleaner. Do not
overtighten nuts, overtightening can create visible dimples on
the plated surface.
To install the trim on the door, first see Opening and Removing Door on
Page 25. Slide the threaded studs on the trim through the holes in the
door. Install the nuts on the studs to secure the trim to the door. Do not
over tighten the nuts or they will snap the studs off. To install the spring
handle, first close the door and screw the handle into the receiving nut.
Then spray a household glass cleaner or water on the shaft of the handle
to act as a lubricant. Next, twist the spring handle counterclockwise
onto the shaft. Use a household glass cleaner or alcohol to remove any
fingerprints prior to firing the stove.
Conversion from Standard 35,000 BTU To Optional 25,000 BTU
Input
To convert input from 35,000 BTUs to 25,000 BTU's, remove and replace
the stock burner orifice with the #36 NG orifice supplied in the optional
orifice kit P/N H5924. Pipe dope or other approved gas line sealant will
need to be applied before inserting into bulkhead. The foil sticker sup­
plied, stating Vision 25/SDVSS25, will need to be affixed over the model
name Vision 35/SDVSS35 on the serial number label.
11