Operating Sequence; Interrupting A Washing Programme; End Of The Washing Programme; Unloading The Dishwasher - Electrolux ESF 4101 Instruction Book

Operating sequence

1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Close the dishwasher door
4. Set and start of the programme
Turn the programme selector dial clockwise until the
letter of the programme you wish to select corresponds
with the programme marker.
Depress the On/Off push button, The On/Off indicator light
illuminates and the machine will start.

5. Interrupting a washing programme

in progress
Interrupt a washing programme in progress ONLY if
it's absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
a) Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point in which it was interrupted.
b) Press the On/Off push button (in this case the On/Off
indicator light turns off). Press the On/Off
push button again; the programme will start from the
point in which it was interrupted.

6. End of the washing programme

The dishwasher will automatically stop.
Switch off the dishwasher by pressing the On/Off push
button, the On/Off indicator light turns off.
Open the door and wait a few minutes before removing
the dishes; in this way they will be cooler and the drying
will be improved.

7. Unloading the dishwasher

Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
13