Table of Contents
Advertisement
3. S
ETUP
AC Power
Replacing the Gobo/Color Gel
3. Setup
This fixture runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line
voltage to which you are connecting it is within the range of accepted voltages.
To determine the power requirements for a particular fixture, see the label affixed to the back
plate of the fixture or refer to the fixture's specifications chart. A fixture's listed current rating
indicates its average current draw under normal conditions.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only
as a 0 to 100% switch.
Always connect the fixture to a circuit with a suitable electrical ground.
This fixture has replaceable gobos and colored gels. Please see the steps below for instructions
on this process.
Remove power to the Gobo Zoom™ LED.
1.
2.
On the underside of the fixture, locate the two thumbscrews that secure the gobo
holder in place.
3.
Remove the thumbscrews and carefully slide the gobo holder vertically apart from the
fixture.
4.
Locate the gobo retainer ring and remove it. Use caution for this step, as the retainer
ring will be under tension. This may cause the ring to be difficult to remove, as well as
unstable after removal. Be careful not to lose it.
5.
Remove any gobo that may already be installed.
6.
Place the new color gel and gobo in position in the gobo holder, shown below.
7.
Reinstall the gobo retainer ring securely.
8.
Slide the gobo holder back into the fixture and tighten the two thumbscrews.
Gobo Holder
Thumbscrews
Color Gel
6
Gobo
Gobo
Retainer Ring
11/24/2010 3:48 PM
Advertisement
Table of Contents
