Table of Contents
Advertisement
Installation
The hob must be installed according to the
instructions supplied.
The hob must be installed by qualified personnel
to the relevant Australian Standards.
The manufacturer will not accept liability, should
the above instructions or any of the other safety
instructions incorporated in this book be ignored.
Please, ensure that, once the hob is installed, it
is easily accessible for the engineer in the event
of a breakdown.
CAUTION: The surface temperature exceeds
95 deg C. To avoid a hazard, underbench
access must be restricted.
When the hob is first installed
Once the hob has been installed, it is important
to remove any protective materials, which were
put on in the factory.
Building In
Building over a cupboard or
drawer
If the hob is to be installed above a cupboard or drawer it
will be necessary to fit a heat resistant board below the
base of the hob on the underside of the work surface.
It is also recommended to carry out the electrical
connection to the hob as shown in diagrams 1 and 2.
Cut Out Size
The dimensions of the cut-out are given in the diagram.
Rectangular cut-out size for hob
1
ON/OFF SWITCH
FLEX
OUTLET
FO 0763
2
ON/OFF SWITCH
FLEX
OUTLET
FO 0764
7
Advertisement
Table of Contents
