General Care And Cleaning; Care / Cleaning Table - Electrolux EI24GC15KS Use And Care Manual

10
Care and Cleaning
Surface Type
• Painted and Plastic
Control Knobs
• Porcelain Enamel
• Burner Grates, Burner Caps
• Surface Burners
• Stainless Steel
Cleaning Recommendations
Cleaning Recommendation
For general cleaning, use hot, soapy water and a cloth. For more diffi cult
soils and built-up grease, apply a liquid detergent directly onto the soil. Leave
on soil for 30 to 60 minutes. Rinse with a damp cloth and dry. DO NOT
use abrasive cleaners on any of these materials; they can scratch.
Clean burner grates in the dishwasher and dry upon removal.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse
with a 1:1 solution of clean water and ammonia. If necessary, cover diffi cult
spots with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse
with clean water and a damp cloth, then scrub with a soap-fi lled scouring
pad. Rinse and wipe dry with a clean cloth. Remove all cleaners or the
porcelain may become damaged during future heating. DO NOT use
spray oven cleaners on the cooktop.
The holes in the burners of your cooktop must be kept clean at all times
for proper ignition and a complete, even fl ame. Clean the burner holes
routinely with a small gauge wire or needle and especially after bad
spillovers which could clog these holes.
To remove, clean and replace sealed burner units; follow the instructions
in General Care & Cleaning section under Cleaning Burners, Grates
and Trivets. For stubborn stains, scrub with soap and water or a mild
abrasive cleanser and damp cloth. Dry the burners thoroughly in a warm
oven for 30 minutes. Then replace them, making sure they are seated
and level. DO NOT put burner units in the dishwasher.
Clean stainless steel with hot, soapy water and a dishcloth. Rinse with
clean water and a cloth. Do not use cleaners with high concentrations
of chlorides or chlorines. Do not use harsh scrubbing cleaners. Only
use kitchen cleaners that are especially made for cleaning stainless steel.
Always be sure to rinse the cleaners from the surface as bluish stains
may occur during heating that cannot be removed.