18 electrolux
Fitting the hob to the worktop
Carry out the building in of the hob
as follows:
1. Place the seals supplied with the hob
on the front edge of the cut out.
Then, place them at 27 mm from the
side edges and at 10 mm from the
rear edge, as shown in the diagram,
taking care that the seals meet
without overlapping.
2. Place the hob in the cut out, taking
care that it is centred.
3. Fix the hob with the relevant fixing
clamps, supplied with the injectors
kit (see diagram). When the screws
have been tightened, the excess seal
can be removed.
The edge of the hob forms a double
seal which prevents the ingress of
liquids.
27
a) seal
27
Fig. 6
a
Fig.7