Abit SL6 User Manual page 22

2-12
Note: Watch the HDD LED pin position and the orientation.
PN1 (Pin 10 - 11): Power on Switch Header
PN1 (Pin 13-14): Hardware Suspend Switch (SMI Switch) Header
hardware.
Note: If the ACPI function in the BIOS setup is enabled, this function will not work.
PN2 (Pin 1-2): Hardware Reset Switch Header
PN2 (Pin 4-5-6-7): Speaker Header
PN2 (Pin 9-10): Suspend LED Header
Note: Watch the Suspend LED pin position and the orientation.
SL6
Attach the cable from the case's front panel
power switch to this header.
Attach the cable from the case's front panel
suspend switch (if there is one) to this
header. Use this switch to enable/disable the
power management
Attach the cable from the case's front panel
reset switch to this header. Press and hold
the reset button for at least one second to
reset the system.
Attach the cable from the system speaker to
this header.
Insert the two-threaded suspend LED cable
into pin 9 and pin 10. If you install it in the
wrong direction, the LED light will not
illuminate correctly.
Chapter2
function through