Install System Memory - Abit KD7-B User Manual

Hardware Setup

2-3. Install System Memory

This motherboard provides 4 184-pin DDR DIMM sites for memory expansion available from minimum
64MB to maximum 3.5GB.
Bank
Bank 0, 1 (DIMM1)
Bank 2, 3 (DIMM2)
Bank 4, 5 (DIMM3)
Bank 6, 7 (DIMM4)
Total System Memory for Unbuffered DDR DIMM (PC1600/PC2100)
Total System Memory for Registered DDR DIMM (PC1600/PC2100)
Total System Memory for Unbuffered DDR DIMM (PC2700/PC3200)
Total System Memory for Registered DDR DIMM (PC2700/PC3200)
NOTE: It is necessary to install one DIMM module at least from memory slot DIMM1.
Power off the computer and unplug the AC power cord before installing or removing memory modules.
1. Locate the DIMM slot on the board.
2. Hold two edges of the DIMM module
carefully, keep
connectors.
3. Align the notch key on the module with the
rib on the slot.
4. Firmly press the module into the slots until
the ejector tabs at both sides of the slot
automatically snaps into the mounting notch.
Do not force the DIMM module in with extra force as the DIMM module only fit in one direction.
5. To remove the DIMM modules, push the two ejector tabs on the slot outward simultaneously, and
then pull out the DIMM module.
ATTENTION: Static electricity can damage the electronic components of the computer or optional
boards. Before starting these procedures, ensure that you are discharged of static electricity by touching a
grounded metal object briefly.
Table 2-1. Valid Memory Configurations
64, 128, 256, 512MB, 1GB
64, 128, 256, 512MB, 1GB
64, 128, 256, 512MB, 1GB
64, 128, 256, 512MB, 1GB
away of touching
Memory Module
its
2-3
Total Memory
64MB ~ 1GB
64MB ~ 1GB
64MB ~ 1GB
64MB ~ 1GB
64MB ~ 3GB
64MB ~ 3.5GB
64MB ~ 2GB
64MB ~ 3GB
User's Manual