Using The Battery - Sanyo SCP-8100 User Manual

Using the Battery

Installing the Battery
Your phone comes with a LiIon battery. Follow these steps to
install it:
1. Place the battery into the space beneath the antenna with the
metal contacts at the bottom, facing downward.
2. Gently press down until it's in place and the battery release
latch snaps.
Removing the Battery
To remove your battery, follow these easy steps:
1. Make sure the power is off so that you don't lose any stored
numbers or messages.
2. Push the battery release latch up and hold the battery.
3. Then pull it up and out at a 45-degree angle.
Charging the Battery
Your phone comes with a rechargeable battery. You should
charge the battery as soon as possible so you can begin using
your phone.
Keeping track of your battery's charge is important. If your
battery level becomes too low, your phone automatically turns
off and you will lose all the information you were just working
on. For a quick check of your phone's battery level, glance at the
battery charge indicator located in the upper-right corner of
your phone's display screen. If the battery charge is getting too
low, the battery icon appears and the phone sounds a
warning tone.
Always use an approved desktop charger, travel charger, or
vehicle power adapter to charge your battery.
Warning!
Using the wrong battery charger could cause damage to your
phone and void the warranty.
Note:
Long backlight settings, searching for service, vibrate mode, and
browser use affect the battery's talk and standby times.
Using the Travel Charger
To use the travel charger provided with your phone:
1. Plug the travel charger into a wall outlet.
2. Plug the other end of the travel charger into the side of your
phone (with the battery installed).
Charging when your phone is turned on:
The battery icon appears on the display while charging.
The battery icon turns to
Charging when your phone is turned off:
The battery icon appears, and the message "BATTERY
CHARGING-Power Off-" is shown on the display while
charging. When the battery is completely discharged, you may
wait for several minutes until the message is shown on the
display. The battery icon turns to
"CHARGING COMPLETE-Power Off-" when charging is
complete.
Tip: Be sure to watch your phone's battery level indicator and charge the
battery before it runs out of power.
when charging is complete.
, and message changes to