Daily Use - Electrolux EGL6382 User Manual

48 www.electrolux.com

3. DAILY USE

WARNING!
Refer to "Safety information"
chapter.
3.1 Ignition of the burner
WARNING!
Be very careful when you use
open fire in kitchen environment.
Manufacturer decline any respon-
sibility in case misuse of the flame
Always light the burner before you
put cookware.
To light the burner:
1. Turn the control knob counterclock-
wise to the maximum position (
) and push it down.
2. Keep the control knob pushed for ap-
proximately 5 seconds; this will let
thermocouple to warm up. If not, the
gas supply will be interrupted.
3.
Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and
its cap are in correct positions.
A) Burner cap
B) Burner crown
C) Ignition candle
D) Thermocouple
WARNING!
Do not keep the control knob
pushed for more than 15 sec-
onds.
If the burner does not light after
15 seconds, release the control
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
In the absence of electricity you
can ignite the burner without elec-
trical device; in this case approach
the burner with a flame, push the
relevant knob down and turn it
counter-clockwise to maximum
gas release position.
If the burner accidentally goes out,
turn the control knob to the off
position and try to light the burner
again after minimum 1 minute.
When switching on the mains, af-
ter installation or a power cut, it is
quite normal for the spark genera-
tor to be activated automatically.
3.2 Turning the burner off
To put the flame out, turn the knob to the
A
symbol
WARNING!
Always turn the flame down or
B
switch it off before removing the
pans off the burner.
C
3.3 Before first use (electric
zones)
D
Put on all cooking zones a pan filled with
some water. Set the maximum position
and operate the appliance for approxi-
mately 10 minutes until water inside the
pans boils. After that, operate the appli-
ance at minimum position for 20 minutes.
During this period, an odour and smoke
can occur. This is normal. Make sure that
the airflow is sufficient.
After this operation, clean the appliance
with a soft cloth soaked in warm water.
To switch on and increase the heat set-
ting turn the knob counterclockwise. To
decrease the heat setting turn the knob
.