Electrolux ERA36633W User Manual page 16

16 electrolux
7. Remove the lower door.
m1
m5
m3
8. Remove the spacer (m6) and move to
the other side of the hinge pivot (m5).
9. Remove using a tool the cover (b1).
Unscrew the lower hinge pivot (b2) and
the spacer (b3) and place them on the
opposite side.
10. Re-insert the cover (b1) on the opposite
side.
11. Remove the stoppers (d1) and move to
the other side of the doors.
12. Remove the left-hand cover pin of the
middle hinge (m3,m4) and move to the
other side.
m2
m6
m4
b1
b2
b3
13. Fit the pin of the middle hinge (m5) into
the left-hand hole of the lower door.
14. Re-insert the lower door on the pivot
pin (b2).
15. Re-screw the middle hinge (m1) on the
opposite side . Do not forget the plastic
spacer (m2) inserted under the middle
hinge.
16. Re-insert the upper door on the middle
hinge (m5).
Make sure that the edges of the doors
run parallel to the side edge of the ap-
pliance.
17. Position and fix the upper hinge (you
can find them in the instruction for use
bag) on the opposite side (t6).
t6
18. Insert the panel (t7) (that can be found
in the instruction for use bag).
19. Open the upper door, attach the top
cover (t2) using screws (t1). Insert the
magnet (d7). Close the door.
20. Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabi-
net.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
t7