Light Bulbs - GE Monogram ZV800 Owner's Manual

Do not use a steel wool pad; it will scratch
Stainless steel
the surface.
surfaces
To clean the stainless steel surface, use warm
(on some models)
sudsy water, a stainless steel cleaner such as
Kleen King
cleaner. Always scrub in the direction of the
grain. Rinse thoroughly with a sponge or cloth
and clean water. Dry with a soft, clean cloth.
Clean any painted surfaces with a mixture
Painted
of water and either soap or vinegar.
Surfaces
(on some models)
Pull the glass visor out and wash it with a damp
Glass visor
soapy cloth. Dry it with a clean cloth and push it
back into place.

Light bulbs

NOTE: The glass cover should be removed only when
cold. Wearing latex gloves may offer a better grip.
CAUTION
bulb, disconnect electrical power to the hood
at the main fuse or circuit breaker panel.
ATTENTION
en place l'ampoule, débranchez le courant de la
hotte en enlevant le fusible principal ou en faisant
basculer le disjoncteur au panneau d'alimentation.
Be sure to let the light cover and bulb cool
completely.
For your safety, do not touch a hot bulb with
bare hands or a damp cloth.
To remove:
1 Insert your finger nail into the inner glass
2 Using gloves or a dry cloth, remove the bulb
To replace:
1 Use a new 12-volt, 20-watt Halogen bulb for
2 Using gloves or a dry cloth, remove the new
3 Push the bulb straight into the receptacle
®
or an all-purpose liquid or spray
: Before replacing the
cover slot and pull down. Remove cover.
NOTE: Do not remove outer retaining ring.
by pulling it straight out.
a G-4 base.
bulb from its packaging.
NOTE: Do not touch the new halogen bulb with
bare fingers. Touching the bulb with bare fingers
will significantly reduce the life of the bulb.
all the way.
Care and Cleaning
After cleaning, use a stainless steel polish, such
as Stainless Steel Magic
Stainless Steel Cleaner
Metal Polish
for cleaning the stainless steel surface.
Do not use commercial oven cleaners, cleaning
powders, steel wool or harsh abrasives on any
painted surface.
: Avant de remettre
ONLY use a new 12-volt, 20-watt Halogen bulb for a
G-4 base.
Receptacle
For improved lighting, clean the glass cover
frequently using a damp cloth. This should be done
when the hood is completely cool.
4 Snap the glass cover into the retaining ring.
5 Reconnect electrical power to the hood.
Chimney Vent Hood
®
, Revere Copper and
® or Wenol All Purpose
® . Follow the product instructions
Receptacle
Glass cover
Use gloves or
cloth
Socket
Bulb
7