Remove The Transport Supports; Cleaning; Installing The Cabinet - Electrolux ER8317C Instruction Booklet

Remove the transport supports

Remove the tape and the transport supports from
·
the door sides
·
inside the door hinges
·
the shelves
Remove the transport support on the glass shelf by
pushing the support forward along the edge of the
shelf until it stops at the protuberance of the shelf.
Take hold of the rear edge of the glass shelf and pull
the shelf and transport support forward until the
shelf tilts and the transport support can be removed.
Some models are fitted with a silencing pad under
the cabinet. Do not remove this pad.

Cleaning

Wash the inside of the cabinet using lukewarm
water, a mild washing-up detergent and a soft cloth.

Installing the cabinet

To otain the best performance from the cabinet, ensure
:
·
the cabinet is placed in a dry, cool place and
is not exposed to direct sunlight.
·
the cabinet is not placed close to a source of
heat, e.g. a cooker or dishwasher.
·
the room in which the cabinet is placed
has a temperature of +16°C to +32°C.
·
the cabinet is level.The cabinet should not lean
against any wall. If necessary adjust the
feet using the supplied adjustment spanner.
·
there is good air circulation around the cabinet
and that the air channels below and behind
the cabinet are not blocked. The ventilation
space above the cabinet and any
grocery/top cabinet must be at least 200 cm2.
The ventilation space can either be
a) directly above the cabinet, or
b) behind and above the top cabinet. In this case,
the space behind the cabinet must be at least
50 mm deep.
a)
12
b)
50mm
Electrolux 818 15 91- -01/0