Troubleshooting - Edimax PS-1210MFn Manual

15. Troubleshooting

1. This product is not found even after searching by the "MFP
Manager".
Check if the power adapter and the network cable are
connected to the MFP Server properly.
Check if the LAN and Ready LEDs are turned on.
Check if the IP Address of the MFP Server is in the network
segment as your computer.
- If you are not sure the IP Address setting of the MFP Server,
please check the TCP/IP setting of the MFP Server from the
"Server Manager".
2. The ways to change the IP Address of the MFP Server.
A DHCP Server is installed in the network
If a DHCP Server is installed, you can setup to let the MFP
Server get IP Address from the DHCP Server automatically.
1. Open "Server Manager" and then select "TCP/IP" setting.
2. Select "Auto IP" and click "Save".
3. Reboot the MFP Server.
Set up the IP Address Manually
1. Open "Server Manager" and then select "TCP/IP" setting.
2. Select "Static IP" and enter the IP Address and Subnet
Mask as your computer. Click "Save".
3. Reboot the MFP Server.
Note:
Set a static IP Address to MFP Server is recommended since
DHCP assignment may dramatically change the IP Address for
MFP Server.
133