Preparing The Logger For Use - Fluke 1743 User Manual

1744/1743
Users Manual

Preparing the Logger for Use

Prepare the 1744/1743 Logger for use with the PQ Log software as follows
(see Figure 3):
1. Connect the Logger to line power. Use the power supply cables to
connect to an outlet, or to the test leads phase and neutral for Wye
configurations, or any two-phase leads for delta.
If you are powering the Logger in parallel with the test
leads, and the voltage under test at the Logger power
supply connections could be greater than 660 V RMS ac,
plug the power supply leads into an outlet instead.
Otherwise, you could damage the Logger.
12
W Caution