Install The Oven (27" [68.2 Cm] Or 30" [75.6 Cm] Installation Only) - Jenn-Air JBS7524BS Instructions Manual

WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
1. Empty oven of any loose contents.
2. For 30" installation, skip this step.
For 27" installation, remove the extension plate from each of
the side brackets by removing the 2 screws.
3. Loosen the middle and rear screws on each side of the oven.
The screws are located at the same height as the door
handle.
4. Place the side bracket over the 2 screws, fitting the screw
heads through the keyholes on the bracket. Then slide the
side bracket down so that the upper portions of the keyholes
rest on the screws.
A. Side bracket
B. Existing screws (middle and rear)
C. Proper side bracket attachment
5. Tighten screws to secure the side bracket to the oven.
6. Repeat steps 4 and 5 on the other side of the oven.
6
Install the Oven
(27" [68.2 cm] or 30" [75.6 cm] Installation Only)
A
B
C
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
7. With the oven near the opening, plug the oven into the
grounded 3 prong outlet.
8. Using 2 or more people, slide oven all the way into the
opening, and center the oven within the opening.
NOTE: The screw holes on the winged ends of both side
brackets (or extension plates for 30" installation) must be fully
over the wood of the wall or cabinet, as shown.
A
A. Door front facing
B. Screw hole for cabinet attachment
C. Cabinet front
9. Using " (2 mm) drill, drill pilot holes into the cabinet through
the screw holes on the side brackets (or extension plates for
30" installation).
10. Install two 1" T10 screws in the pilot holes to secure the oven
in place.
NOTE: To ensure proper side trim panel fitting, do not overtighten
screws.
11. Open oven door.
12. Position the tabular portion of the side trim panel behind the
door facing frame, then firmly push the outside edge of the
trim behind the side bracket, as shown.
B C