Table of Contents
Advertisement
18 electrolux drying
The last 10 minutes of the drying cycle
correspond to an anti-crease phase.
During this time the door is locked and
the display keeps showing three
0.00
flashing zeros «
Note!
If you whish to open the door before or
during the anti-crease phase or to inter-
rupt it, press any button or turn the pro-
gramme selector dial to any programme
position (except «O»), the door can be
immediately opened.
6. Turn the selector dial to the «O»
position to switch the machine off.
Remove the laundry.
Automatic washing and drying
(NON-STOP programme)
For NON-STOP programmes, it is also
essential not to exceed the maximum
load sizes of 3.5 kg for cotton and 2 kg
for synthetics.
Do not use a dosing device/ball
whe n carrying out a washing & dry-
ing programme.
1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on by turning
the selector dial to the selected
washing programme/fabric.
4. Select the required options by
pressing the relevant buttons.
»
Note!
If possible, do not select a spin speed
lower than that proposed by the appli-
ance to avoid a too long drying time so
saving energy.
In any case the reduction of the spin
speed is only possible after selecting
drying.
The lowest values you can select are
the following:
- 900 r.p.m. for cottons and syn-
thetics with electronic drying
- 900 r.p.m. for cottons and 700
r.p.m. for synthetics with timed
drying
5. Select the drying time or dryness
degree by pressing buttons
5
). The display shows the
entire duration of the washing and
the selected drying cycle.
6. Start the programme by pressing
8
button
. After the programme
has started, the time remaining is
updated every minute.
7. At the end of the programme turn
the selector dial to the «O» position
to switch the machine off.
8. Remove the laundry.
4
or
Advertisement
Table of Contents
