Table of Contents
Advertisement
10 electrolux
USE OF DETERGENT AND RINSE AID
1
2
30
20
7
Use of detergent
To help the environment, do not use
more than the correct quantity of deter-
gent.
Obey the instructions on the detergent
packaging.
How to fill the detergent dispenser:
1. Press the release button
7
lid
of the detergent dispenser.
2. Put the detergent in the dispenser
3. If the washing programme has a pre-
wash phase, put a small quantity of de-
tergent on the inner part of the appli-
ance door.
4. If you use the detergent tablets, put the
tablet in the detergent dispenser
5. Close the detergent dispenser. Press
the lid until it locks into position.
Use long washing programmes when
you use the detergent tablets. These
MULTITAB FUNCTION
The multitab function is for combi detergent
tablets.
These tablets contain agents as detergent,
rinse aid and dishwasher salt. Some types
of tablets can contain other agents.
Do a check if these tablets are applicable
for the local water hardness. Refer to the in-
structions from the manufacturer.
When you set the multitab function, it stays
on until you deactivate it.
3
4
A
-
+
6
5
2
to open the
1
.
1
.
cannot fully dissolve with short washing
programmes and can decrease the
washing results.
Use of rinse aid
Rinse aid makes it possible to dry the
dishes without streaks and stains.
The rinse aid dispenser automatically
adds rinse aid during the last rinsing
phase.
Do these steps to fill the rinse aid dispens-
er:
1. Press the release button
5
lid
of the rinse aid dispenser.
2. Fill the rinse aid dispenser
aid. The mark 'max' shows the maxi-
mum level.
3. Remove the spilled rinse aid with an ab-
sorbent cloth to prevent too much foam
during the washing programme.
4. Close the rinse aid dispenser. Press the
lid until it locks into position.
Adjust the rinse aid dosage
Factory set: position 3.
You can set the rinse aid dosage between
position 1 (lowest dosage) and position 4
(highest dosage).
Turn the rinse aid selector
decrease the dosage.
The display shows a message when
the rinse aid dispenser is empty
The message does not show while a
washing programme operates.
The multitab function deactivates the flow
of rinse aid and salt.
The multitab function deactivates the salt
and the rinse aid messages.
The programme duration can increase if
you use the multitab function.
6
to open the
3
with rinse
4
to increase or
Advertisement
Table of Contents
