Table of Contents
Advertisement
Rearranging
the shelves
Slide-out
spillproof
shelf
QuickSpace
™
shelf
12
Shelves in the refrigerator compartment
are adjustable.
Refrigerator Compartment
To remove:
Remove all items from the shelf.
1
Tilt the shelf up at the front.
2
Lift the shelf up at the back and bring
3
the shelf out.
To replace:
While tilting the shelf up, insert the top hook
1
at the back of the shelf in a slot on the track.
Lower the front of the shelf until the bottom
2
of the shelf locks into place.
The slide-out spillproof shelf allows you to reach
items stored behind others. The special edges
are designed to help prevent spills from dripping
to lower shelves.
To remove:
Remove all items from shelf.
1
Slide the shelf out until it stops.
2
Lift the front edge of the shelf until the central
3
tabs are above the front bar.
Continue pulling the shelf forward until
4
it can be removed.
To replace:
Place the rear shelf tabs just in front
1
of the central notches on the shelf frame.
Slide the shelf in until the central tabs
2
are slightly behind the front bar.
This shelf splits in half and slides under itself
for storage of tall items on the shelf below.
This shelf can be removed and replaced or
relocated just like Slide-Out Spillproof Shelves.
On some models, this shelf can not be used
in the lowest position.
Shelves and Bins
Stainless Steel Refrigerator
2
Some models have wire shelves that
can be adjusted in the same manner.
2
Lower the shelf into place until it is horizontal
3
and slide the shelf in.
Make sure that the shelf sits flat after reinstallation
and doesn't move freely from side to side.
Make sure you push the shelves all the way
in before you close the door.
Advertisement
Table of Contents
