GE Professional Rangetop Installation Instructions Manual page 16

Installation Instructions for Gas Conversion
3 CHANGE BURNER ORIFICES (cont.)
IMPORTANT: Find your model number below. Read
each orifice label to identify and install them in the
exact locations shown.
ZDP304 SIMMER ORIFICES
ZDP304 MAIN ORIFICES
A 84XL or
126HXN orifice
will be used
on these three
burners.
ZDP364, ZDP366, ZDP484, ZDP486
SIMMER
ORIFICES
MAIN
ORIFICES
A. Return the unused orifices to the holder. Reattach
the holder and the instruction sheet with screw
in the original storage location.
B. Replace the burner heads, caps and top grates.
On range models, replace rear vent trim.
A 34SL or 51SN orifice
will be used on all burners.
Use a 108XL
or 190XN orifice
for the right
front burner.
A 34SL or 51SN orifice
will be used on all
burners.
Use 108XL or
190XN orifices
for all burners.
4 CHANGE GRILL ORIFICE
Locate the 1–1/2" long Grill orifice.
Select for your gas type. LP
A. Remove the grill cover,
grates and grate frame. Lift
the radiant baffle straight
up and off.
B. Remove the 2 hex
head screws from
the top of the igniter.
• Remove one screw
from each side of
the burner surround.
• Lift out the surround.
C. Carefully push the
igniter aside and
under
the burner.
Do not pull or pinch
the wire.
Remove 4 burner
attachment screws,
2 at the front and 2
at the back. Slide the
burner assembly
toward the back and
out of the gas inlet.
D. Use a 1/2" deep well
socket to remove
and replace the orifice .
Reverse these
steps to re-assemble
the grill. Be sure to
place the unused
orifice in the holder
for possible future use.
16
(if present)
— —
.047, NAT .067
Remove 2
hex head
screws
Surround
Screws
Burner
Surround
Assembly
Front of Range
Igniter
Burner