Maintenance & Cleaning - Jetta Classic Series Owner's Manual & Installation Manual

Cleaning...
1. Cleaning should be done with a damp cloth and a window cleaner (i.e. Glass Plus, Windex, etc.).
WITH ANY SOLVENTS. Do not use an abrasive or chemical based cleanser of any kind. The fittings should
be wiped off with a damp cloth only. Bubble Bath or bath oils are not recommended for whirlpool, air or
combination baths. See dealer for specific cleaners.
2. If you desire additional lustre on your bath surface, you may use a good automotive wax recommended
for plastic surfaces. Do not wax the floor, for this may cause a slip hazard. Light scratches and abrasions
may be removed and the original gloss restored by using a light buffing compound. Use a damp cloth, rub
in small circles until scratches or abrasions are gone, then wipe with a dry cloth until the original gloss is
restored.
3. Repairs of any kind, if necessary, should be done by qualified acrylic experts.
4. Proper installation and maintenance will ensure years of service and make you proud to own a bath by
Jetta Corporation.
It is recommended that your whirlpool, air or combination system be flushed twice per month. More frequent
service may be required depending on usage.
flUShING PROCEDURE...
1. Fill your bath with hot water.
2. Add 2 tablespoons of low-foaming automatic dishwasher detergent (i.e. Cascade, Sunlight, etc.)
3. Add 1/2 cup of household bleach to the water.
4. Run the whirlpool for a minimum of fifteen minutes.
5. Drain Bath
6. Refill with cold water and operate the whirlpool for fifteen minutes.
7. Drain Bath.
NEVER operate a whirlpool bath without first filling the tub with water to 2" above
operating jets (some models allow upper jets to be shut down for operation at a
lower water level).
Repair...
If any problems should develop, call your installer, dealer or the factory at (800) 288-7771.
.
© 2011 Jetta Corporation All rights reserved. REV 06/2011
www.jettacorp.com
owner's manual
maintenance
Verbiage Copy
&
cleaning
NEVER
9