Operating Instructions - Optional Air Bath - Jetta Classic Series Owner's Manual & Installation Manual

owner's manual
operating instructions for optional air bath feature
4 Button Bath Control
Stand-alone Blower, Light, Speed Buttons
Power Up
Upon power up, the LEDs flash as
the bath control goes through a self
diagnostic check. Once the LEDs stop
flashing, you may use the control.
Session Timer
Turning on a device starts a Session
Timer that lasts for 30 minutes.
Optional Heated Quite-Flo Blower
Any time the blower turns on, the
heater turns on with it.
Mood Light
2" Bath Light 7 LED Bulb Cluster
(59200, Front Access)
12
Blower
Increase Speed
Blower On - Off
Increase/Reduce Speed
Modes (begin with blower off)
Light
Blower 600w Htr 115v 3spd
(8141-6320
8' Water
Detect Cable
(99742)
(Optional)
Bulb Holder with
2 pin Amp plug
(59007-V) (59102)
If the Blower is off, press the Blower button once to turn the Blower On at
its highest speed, or
If the Blower is on, press the Blower button once to turn the Blower Off.
Press and hold the + or - button to increase or decrease the speed smoothly.
Press the Blower button twice to put the Blower in Pulse mode, or
Press the Blower button three times to put the Blower in Wave mode.
If you have a light installed, the light can be controlled independently of all
other features.
Some lighting options have unique operation for color changes.
See the manual for any special light system that may be installed.
)
Light Adapter Cable
4 Pin Din to 2 pin Amp plug
(25750)
Verbiage Copy
Light
Reduce Speed
Cable Bath 8 Pin
Control Panel
Mini Din 6ft
(90013-RV*)
(25569)
(*Rev. #)
.
© 2011 Jetta Corporation All rights reserved. REV 06/2011
800-288-7771