Operating Instructions - Classic Series - Jetta Classic Series Owner's Manual & Installation Manual

owner's manual
operating instructions
The bath should be filled 2" over the directional jets BEFORE turning the pump on.
Directional Body jets:
To increase the directional jet pressure, grasp the outer ring of
the jet and turn clockwise, to reduce jet pressure turn the outer
ring
counter-clockwise.
To adjust the jet direction, use your finger to position the jet
nozzle to the desired location.
To remove jet, grasp the outer ring of the jet and turn counter
clock-wise until the jet clicks – then pull jet out.
To install a jet, insert the jet into the jet housing (do not force
the jet) and turn clockwise until the jet clicks – will pass a
point of resistance.
When bathing is complete, the pump must be turned off and the bath emptied. Adjust the inner
nozzle portion of the all the jets in a downward position while draining the bath, to allow the bath
to drain properly.
Note: to enhance your bathing experience feel free to use Jetta recommended aromatherapy (i.e.
inSPAration) as it is specifically designed not to clog the system or damage the piping. Oil, bathing
salts, and bubble bath solutions are not recommended.
10
Classic Series
Verbiage Copy
.
© 2011 Jetta Corporation All rights reserved. REV 06/2011
800-288-7771