Operating Instructions - Designer/Elite Series - Jetta Classic Series Owner's Manual & Installation Manual

The bath should be filled 2" over the jets BEFORE turning the pump on.
Rotating Back Jets:
To increase the jet pressure, grasp the outer ring of the jet
and turn clockwise; to reduce jet pressure turn the outer ring
counter-clockwise.
The upper rotating back jets can be shut-down for operation at
a lower water level. When shut down, the rotating jets will still
have a small flow of water.
To increase rotation, use your finger to position the jet nozzle
closer to the outer ring; to decrease rotation, position the jet
nozzle closer to the center of the jet.
Directional Body jets:
To increase the jet pressure, grasp the outer ring of the jet
and turn clockwise, to reduce jet pressure turn the outer ring
counter-clockwise.
To adjust the jet direction, use your finger to position the jet
nozzle to the desired location.
To remove jet, grasp the outer ring of the jet and turn counter
clock-wise until the jet clicks – then pull jet out.
To install a jet, insert the jet into the jet housing (do not force
the jet) and turn clockwise until the jet clicks – will pass a
point of resistance.
When bathing is complete, the pump must be turned off and
the bath emptied. Adjust the inner nozzle portion of the all the jets in a downward position while
draining the bath, to allow the bath to drain properly.
Note: to enhance your bathing experience feel free to use Jetta recommended aromatherapy (i.e.
inSPAration) as it is specifically designed not to clog the system or damage the piping. Oil, bathing
salts, and bubble bath solutions are not recommended.
.
© 2011 Jetta Corporation All rights reserved. REV 06/2011
www.jettacorp.com
Designer & Elite Series
owner's manual
operating instructions
Verbiage Copy
11