Operation - American DJ SWEEPER BEAM QUAD LED User Instructions

Sweeper Beam Quad LED
VER
- With this function you can display the version soft-
ware of the fixture.
1. Tap the MENU button until "VER" is displayed, press ENTER.
2. The software version will now be displayed. Press MENU to
exit.
RSET
- Use this function to reset the unit.
1. Press the MENU button until "RSET" is displayed, press
ENTER.
2. The fixture will now reset.
Sweeper Beam Quad LED
Blackout Blackout the fixture
1. Sound Strobe (Full on).
Function
2. Auto Strobe (Full on).
Mode Random Show(LED OFF)
Sweeper Beam Quad LED
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 4 fixtures maximum. After 4 fixtures you will need
to use a new power outlet. They must be the same fixtures. DO
NOT mix fixtures.
ADJ Products, LLC - www.adj.com - Sweeper Beam Quad LED User Manual Page 15
System Menu
UC3 Control
Select Shows (Show 1-16).
Show(LED ON)
Power Cord Daisy Chain
Sweeper Beam Quad LED
Operating Modes: The Sweeper Beam Quad LED can operate
in three different modes. In each mode you can run the fixture
as a stand alone fixture or in a master/slave confiugration. This
next section will detail the differences in the operating modes.
• Sound Active mode -
The fixture will react to sound, chasing through the built-in programs.
• Show mode -
Choose 1 of 12 show modes to run.
• DMX control mode -
This function will allow you to control each individual fixtures traits
with a standard DMX-512 controller such as the Elation
Designer.
™
Master-Slave Operation
This function will allow you to link up to 16
units together and operate without a controller. The units will be sound
activated. In Master-Slave operation one unit will act as the controlling
unit and the others will react to the controlling units programs. Any unit
can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. Set the Master unit to your desired operating mode, then set the
unit to the Master setting.
3. For the slave units
press the MENU button until "SLND" is dis-
played, and Press ENTER. Set the slave units to either "SL 1" or
"SL 2".
4. The slave units will now follow the Master unit.
Universal DMX Control:
universal DMX-512 controller to control the chases and patterns,
dimmer and strobe. A DMX controller allows you to create unique
programs tailored to your individual needs.
1. The Sweeper Beam Quad LED has 4 DMX Channel modes; 1
ADJ Products, LLC - www.adj.com - Sweeper Beam Quad LED User Manual Page 16
This function allows you to use a Elation

Operation

Show
®
®