Farenheit TID-893 Owner's Manual page 9

4. Button/
Button
In RADIO mode, press to start automatic searching, press and hold for two seconds to start
manual searching, then press to tune each frequency step downward.
In DVD / SD / USB mode, press
for two seconds to activate fast reverse (REW) search in a track.
In Bluetooth mode, press to make a call after inputted a phone number or accept an incoming
call.
5. VOL Knob / POWER Button
Press it to turn on the unit, press it again to turn the unit off.
(* Press any button to turn on the unit except REL button and EJECT button on panel, and
EJECT button on remote control)
VOL Knob: Adjust the volume level by turning the knob clockwise to increase or
counterclockwise to decrease.
DUAL KEY setting:
only), D-DAUL (Buttons on panel and RC control DVD only)
6. BAND/TILT Button
In Radio mode, press to change radio band in sequence of FM1 →
AM2.
Press and hold for 2 second to adjust the Monitor tilt angle: TILT ANGLE 1 => TILT ANGLE 2
=> TILT ANGLE 3 => TILT ANGLE 4.
7. / PLAY / PAUSE / Button
In Disc, USB, SD CARD mode, press it to pause / play. Press it again to resume playback
8. Button/ button
In Radio mode, press to start automatic searching, press and hold for two seconds to start
manual searching, then press them to tune each frequency step upward.
In DVD / SD / USB mode, press
two seconds to activate fast forward (FF) search in a track.
In BLUETOOTH mode, press to reject a coming call or hang up while calling.
9. IR Sensor
IR Remote control signal receiving window. Max distance is 6-8 meters, 45 angels.
10. DISC slot
11. Info Display
Information Display LCD when operation the unit.
12. AV-in Jack
Put the AV plug into the AV-IN jack which was marked on front panel.
13. USB slot
14. OPEN Button
Press this to open and close the TFT monitor. WARNING: Do not obstruct the monitor while in
the opening or closing cycle, this may cause damage to the monitor mechanism and is NOT
covered under warranty.
15. EJECT Button
Press to eject a disc. If the disc is not removed for about 10 seconds after eject, the disc is
reinserted automatically.
16. TFT display
17. RESET Button
Press it with a thin, sharp object. The device will then be reset to factory default settings.
18. SD/MMC CARD slot
button to skip to the previous track. Press
Long press it to choose C-DUAL/D-DUAL (Buttons on panel and RC control radio
button to skip to the next track. Press
9
button and hold
FM2 → FM3 → AM1 →
button and hold for