AVERATEC Notebook computer User Manual page 39

Change User Password
With a User password, you can enter the Setup Utility and change or remove the User
password, but you cannot enter the Setup Utility and change or remove the Supervisor
password, nor enable diskette access if it has been disabled.
Change Supervisor Password
A supervisor password must be set before a lower-level user password can be set. After
selecting Change Supervisor Password, press Enter. You will be prompted for the
new password, and then again to verify it. Type in 6 or fewer keystrokes. If you make an
error, press Esc to start over.
Resetting the CMOS to Default Settings
The main page provides the system parameters for you to reset the CMOS to default
settings. After you enter this page, select the Load Optimal Defaults:
Select [OK] to reset the CMOS to default settings.
Exiting and Saving
Save Settings
and Exit
Exit Without
Saving
Load Optimal Defaults?
[OK] [Cancel]
Select this option to save changes to the field
values, and restart the computer using the new
values. (Pressing F10 from any of the menu
screens also allows you to save settings and exit.)
Select this option to discard any changes you have
made to the field values, and restart the computer
using the old values.
39 of 48