Your new Cooker Hood Using your new Cooker Hood is very simple. Nevertheless, to get the best results it is important that you read this handbook thoroughly before installing and using your appliance for the first time. Electrical Requirements Any permanent electrical installation must comply with the latest I.E.E. Regulations and local electricity company regulations.
Contents Page Electrical Requirements Get to know your Cooker Hood Installing your Cooker Hood Installation Mounting Height Thermal cut-out Mounting beneath Cabinets Operating your Cooker Hood The Controls Do’s and Don’ts Caring for your Cooker Hood 9-10 Filters and their Replacement Cleaning How to Replace the Light Troubleshooting...
Get to know your Cooker Hood. Unpacking Before installation, ensure that you have removed all packing pieces. Care should be taken that the fixing kit, ducting spigot and literature pack are retained. View of the Cooker Hood Motor switch Light switch Work surface lamp Grille Dimensions...
Installing your Cooker Hood This Cooker Hood is guaranteed and will give connection (Fig. 1 ). lasting service. The maximum length of ducting, including The guarantee is only applicable if the hood one 90˚ bend should be 3 metres, to be has been installed in accordance with the reduced by 1 metre for each 90˚...
Installing your Cooker Hood NOTE: The hood is more efficient in the Mounting beneath cabinets on the Wall: exhaust mode, therefore this position Before fitting the hood beneath any type of should be selected during the warmer wall cabinet/canopy housing, ensure it is months of the year when no heating is firmly fixed to the wall in accordance with the being used.
Page 7
Installing your Cooker Hood Fixing the Cooker Hood After having adjusted the hood for the version required, it may be installed. - This appliance is designed for fitting in a cabinet or some other support. - The opening to be made on the bottom of the wall hung cabinet must correspond with the measurements shown in fig.
Operating your Cooker Hood The Controls Make sure that the Cooker Hood is wired in Work Top Illumination and the power supply is switched on. There is a separate selector for the light. This selector controls the worktop illumination. Fan Speed Position 1 indicates the illumination is Your Cooker Hood has three speeds to give operating.
Caring for your Cooker Hood Before doing any cleaning or replacing the THE CARBON FILTER - filters or light bulb, always ensure that the (Recirculation only) electricity supply to the Cooker Hood is The carbon filter is an optional extra and is to switched ‘OFF’...
Caring for your Cooker Hood Cleaning: Before doing any cleaning or replacing the filters or light bulb always check that the electricity supply to the hood is switched off. For your own safety and in the interest of hygiene your Cooker Hood needs to be kept clean.
Troubleshooting. First, don’t panic! Parts There may be nothing wrong at all. Look for Please remember your new appliance is a your problem below, then check the things we complex piece of equipment. suggest. More often than not, this will give you the answer to your problem, and you’ll be able ‘DIY’...
Republic of Ireland: (01) 842 6836 08701 54 64 74 For further product information All Creda Services are offered as an extra benefit and do not affect your statutory rights. General Domestic Appliances Limited, Morley Way, Peterborough, PE2 9JB Part No. FP076-01...
Need help?
Do you have a question about the CRU30 and is the answer not in the manual?
Questions and answers