Page 1
USER MANUAL 60CM DECORATIVE COOKER HOOD MODEL/S V 1.0 C60AHBG...
Page 2
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions, or online at www.creda.co.uk If you still require further assistance, call one of our experts on 01759 487836.
USER MANUAL Contents — PAGE Safety instructions General View Accessories Installation Mounting Instructions Control Panel Maintenance and cleaning Troubleshooting Help and Assistance...
USER MANUAL SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS READ CAREFULLY AND KEEP FOR • FUTURE REFERENCE • It is recommended that the product be installed by authorized persons. Installation by unauthorized persons could lead to poor operation performance, damage to the product, and accidents. The product will not be covered by the warranty.
USER MANUAL INSTALLATION Distances Mounting Distance between the cooker and the cooker hood must be considered prior to assembly. The distance between the cooker and the cooker hood should be at least 65 cm.
USER MANUAL Mounting Instructions Attach the mounting template to the wall at the distance (65 cm) shown in Figure 1. Drill through points A and C with Ø8 mm drill bit. At the B points, drill the chimney mounting plate with a Ø6 mm drill bit, considering the distance to the ceiling and the maximum length of the flue.
Page 9
USER MANUAL Carbon Filter Assembly Open the product cover and take out the aluminum filter. (see figure 3) Turn the carbon filter in the direction of the arrow by pressing the sides. (see Fig. 4) Carbon Filter Flap Assembly Attach flap tabs to points A as shown in Figure 5. Complete the assembly process so that the nails remain on the upper surface as shown in Figure 6.
Page 10
USER MANUAL Flue Installation Fix the outer flue to the body from point A with Ø3.5 x 9.5 mm screw. Insert the inner flue into the outer flue and fix it at the B points with Ø3.5 x 9.5 mm screws. Air Outlet Connection Air discharge can be done by flue connection (air discharge to the external environment) or by filtering the air back to the environment (carbon filter).
Page 11
USER MANUAL Flueless use The absorbed air is delivered to a flue or outdoor environment with the help of a pipe attached to the blower motor outlet of the hood in use with flue connection. WARNING: Since carbon filters are optional parts, they must be purchased from the service at an additional fee.
USER MANUAL MAINTENANCE AND CLEANING WARNING: Prior to each maintenance and cleaning, the unit must be unplugged or the fuse to which it is connected must be disconnected. 1. Pay attention to clean the appliance, especially immediately after cooking fried foods. 2.
Page 13
USER MANUAL Aluminum Filter Removal Pull the aluminum filter towards you by pressing it down as shown in figure 10. Reverse the process to install the filter. Note: Avoid bending the aluminum filter to prevent damage. Figure 10 EFFICIENT USE OF THE DEVICE Use 150 / 120 mm diameter pipes and as few elbows as possible when connecting the cooker hood to the chimney.
USER MANUAL TROUBLESHOOTING Error Description Solution Check the electrical connection. The cooker hood does not work. Check engine switch. The engine switch should be in the on position. Check the electrical connection. Lightning lamp does not work Check engine switch. Lamp switch must be at "on" position. Check the aluminum filter Aluminum filter should be washed once a month under normal conditions.
Local call rates apply* Lines open 9am-5:30pm Monday to Friday *Calls to Creda enquiry lines may attract a charge and set up fee from residential lines depending on your call plan/tariff. Mobile and other providers costs may vary, see www.bt.com/pricing for details.
Page 16
• Specifications are subject to change without notice. • Creda disclaim any liability for loss or damage arising from the breakdown of the product. • This guarantee is in addition to and does not diminish your statutory or legal rights.
Page 17
USER MANUAL Declaration of conformance to product standards This appliance conforms to all relevant standards applicable to domestic appliances sold in the UK. Disposal This appliance/fitting is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
Page 18
USER MANUAL This page is intentionally left blank...
Page 19
USER MANUAL This page is intentionally left blank...