Special Tools - Generator - Westerbeke 11.5KW-60Hz Service Manual

SPECIAL TOOLS· GENERATOR
FIELD FABRICATED TOOLS
These drawings provide a means by which simple tools can
be made to assist in the removal of the generator end from
the engine and in the replacement of the generator end on the
engine. A local machine shop should be able to fabricate these
tools
at
a modest price, but first cbeck with your local WEST-
ERBEKE dealer to see if these tools are on hand for loan.
Housing Puller Tool
This tool allows the bearing in the generator housing to be
gently pushed straight off the housing without any twisting.
If a nut of the same specifications as that of the tapped hole
in the pilot tool were to
be
welded on the end of the eye bolt,
this tool would be able to pull the bearing back into place
without any twisting. Please refer to these drawings before
the generator end is removed.
HOUSIHG PUllER TOOL
(FIELD FABRICATED)
3.346" (85
mmlT-~
Dla
B.C~
4"
112·13 UNC Slore-boughl
eye bon wlUr lapered lip.
Weld a
!-?;!:.~r~:..~~~~~~'
IO,...t::::::::;:Z::::==:::I'
one sIde olthl. cenler hole.
1/2" (12.7 mm) Dla.
Drill Typ. 4 hole. Material: Cold·rolled Ste.1
Lifting Eye Tool
This tool allows a mechanic to safely remove the generator
end from ·the engine by attaching this Generator End Lifting
Eye to the four screw holes located under the control panel.
To use this Lifting Eye, remove the generator's controi panel
and screw the Lifting Elye to the generator end.
1·1/4" 5/8"
(31.75 mm) (15.9 mm)
~/f
2-1/2"
(63.5 mm)
4 HOLES
1/4"
(6mm)
Cenl;,r IIntng eye on
baseplale and weld securely.
Disk Alignment Tool
This tool allows a mechanic to safely remove and install the
generator drive disks by aligning the disks with the Drive .
Plate Guide Pin. The Pin screws into the flywheel and acts as
a guide. Also .the pin helps to support some of the rotor and ..
the drive plate's weight while removing or replacing these
parts.
Olfllllww!}}m
,
Material: One
M8
bolt with the hex head machined off and a
screwdriver slot cut in the machined end.
Pilot Tool
. The tool below helps keep the rotor from damaging the
windings in the generator housing to be removed straight off
the engine or to
be
placed straight on the engine. Refer to the
removal and replacement diagram at the bottom of the page.
1
<
8" ,
I
(20302 mm)
ROUND TIP
(6:3~:~f~§>1
12"
I
:J
j
15.5 mm Drill 1-<-<-----(304.8
mm)I-------'---~
1·1/4" (31.75 mm) Deep
M18x1.5Pllch
Tap 1" (25.4 mm) Deep
PROPER USE OF HOUSING PULLER
Material: Aluminum
""" WESTERBEICE
EngInes & Generators
94
j