Mitsubishi 4G6 Manual page 58

11B-22
<M/T>
Flywheel
MD998781
Crankshaft
rear oil seal
MD990938
MD998776
ENGINE <6A1> -
REMOVAL SERVICE POINTS
AA" TRANSMISSION ASSEMBLY REMOVAL
<M/T>:
Refer to GROUP 22.
Caution
Do not remove the flywheel mounting bolt shown by the
arrow. If this bolt Is removed, the flywheel will become
Bolt
out of balance and damaged.
<A/T>:
Refer to GROUP 23.
AB" PLATE <M/T>/ADAPTER PLATE/FLYWHEEL
Use the special tool to secure the flywheel or drive plate,
and remove the bolts.
INSTALLATION SERVICE POINTS
"AA CRANKSHAFT REAR OIL SEAL INSTALLATION
Crankshaft
1. Apply a small mount of engine oil to the entire
2. Install the oil seal by tapping it as far as the chamfered
"BA DRIVE PLATE <A/T>/FLYWHEEL <M/T>/ADAPTER
1. Clean off all sealant, oil and other substances which are
2. Apply oil to the bearing surface of the flywheel or drive
3. Apply oil to the crankshaft thread holes.
4. Apply sealant to the threaded mounting holes.
5. Use the special tool to hold the flywheel or drive plate
Crankshaft Oil Seal
<M/T>/DRIVE PLATE <A/T> REMOVAL
circumference of the oil seal lip.
position of the oil seal case as shown in the illustration.
PLATE/PLATE <M/T> INSTALLATION
adhering to the threaded bolts, crankshaft thread holes
and the flywheel or drive plate.
plate bolts.
Specified sealant: 3M Stud locking 4170 or equivalent
in the same manner as removal, and install the bolt.