Mitsubishi 4G6 Manual page 35

<M/T>
Flywheel
MB991453
ENGINE <4G6> -
REMOVAL SERVICE POINTS
AA" POWER STEERING OIL PUMP AND BRACKET
Remove the power steering oil pump and bracket assembly
from the engine with the hose attached.
NOTE
Place the removed power steering oil pump in a place where
it will not be a hindrance when removing and installing the
engine assembly, and tie it with a cord.
AB" A/C COMPRESSOR REMOVAL
Disconnect the A/C compressor connector and remove the
compressor from the compressor bracket with the hose still
attached.
NOTE
Place the removed A/C compressor where it will not be a
hindrance when removing and installing the engine assembly,
and tie it with a cord.
AC" TRANSMISSION ASSEMBLY REMOVAL
<M/T>:
Refer to GROUP 22.
Caution
Do not remove the flywheel mounting bolt shown by the
arrow. If this bolt Is removed, the flywheel will become
out of balance and damaged.
Bolt
<A/T>:
Refer to GROUP 23.
AD" ENGINE MOUNT BRACKET REMOVAL
MZ203827
1. Support the engine with a garage jack.
2. Remove the special tool which was attached when the
3. Hold the engine assembly with a chain block or similar
4. Place a garage jack against the engine oil pan with a
AE" ENGINE ASSEMBLY REMOVAL
After checking that all cables, hoses and harness connectors,
etc., are disconnected from the engine, lift the chain block
slowly to remove the engine assembly upward from the engine
compartment.
Engine Assembly
ASSEMBLY REMOVAL
transmission assembly was removed.
tool.
piece of wood in between, jack up the engine so that
the weight of the engine is no longer being applied to
the engine mount bracket, and then remove the engine
mount bracket.
11A-35