Mitsubishi 4G6 Manual page 52

11B-16
ENGINE <6A1> -
<Rear bank>
Pre-removal and Post-installation Operation
D Air Intake Plenum Removal and Installation
(Refer to GROUP 15.)
D Timing Belt Removal and Installation
(Refer to P.11B-26.)
Removal steps
1. Breather hose connection
2. Blow-by hose connection
6. Spark plug cable
7. Rocker cover
Camshaft and Camshaft Oil Seal
7
3.4 Nm
28 - 34 Nm
9
8
88 Nm
REMOVAL SERVICE POINTS
AA" RADIATOR UPPER HOSE/RADIATOR LOWER
After making mating marks on the radiator hose and the hose
clamp, disconnect the radiator hose.
D Distributor Removal and Installation
(Refer to GROUP 16.)
D Drive Belt Tension Adjustment (Refer to P.11B-5.)
6
1
12
13
AB" "CA 8. Camshaft sprocket
"BA 9. Camshaft oil seal
12. Rocker arm and shaft assembly
AC"
"AA 13. Camshaft
HOSE DISCONNECTION
Apply engine oil to all
sliding parts when
installing.
2