Running A Printer Check - Epson WorkForce WF-7010 User Manual

Light status
The paper light is
flashing
The power,
and paper light are
flashing
An ink out light is
flashing
An ink out light is on
All lights are flashing
The black and yellow
ink out lights are
flashing
The paper and
out lights are flashing
alternately
Parent topic:
Related references
Paper Jam Problems Inside the Product
Paper Jam Problems in the Cassette
Paper Jam Problems in the Duplexer
Where to Get Help
Related topics
Loading Paper
Replacing Ink Cartridges

Running a Printer Check

Running a printer check helps you determine if the printer is operating properly.
Condition/solution
Paper has jammed in the printer. Check in the cassette, inside the printer,
and in the duplexer to remove the jammed paper. Then press the
feed button to clear the error.
ink out, The cover is open. Close the cover.
An ink cartridge is low. Make sure you have a replacement cartridge.
An ink cartridge is expended or not installed correctly. Replace the indicated
cartridge. Make sure the cartridge is installed correctly
Printer error. Check in the cassette, inside the printer, and in the duplexer to
remove the jammed paper. Turn the printer off and then back on again. If the
error does not clear, contact Epson.
The firmware update has failed, and the printer is in recovery mode. Visit
Epson's support website at
www.epson.ca/support
update.
ink The ink pads are near or at the end of their service life. Contact Epson for
support. (To continue printing, press the
Solving Problems
www.epson.com/support
(Canada) for instructions on repeating the firmware
paper button.)
117
paper
(U.S.) or