When You Cannot Make Clear Copies - Savin Pro 1106EX Operating Instructions Manual

When You Cannot Make Clear Copies

This section explains likely causes of and possible solutions for unclear copies.
Problem
Copies appear dirty.
Copies appear dirty.
The reverse side of an
original image is copied.
The reverse side of an
original image is copied.
A shadow appears on
copies if you use pasted
originals.
The same copy area is
dirty whenever making
copies.
The same copy area is
dirty whenever making
copies.
Copies are too light.
Copies are too light.
Copies are too light.
Parts of images are not
copied.
Parts of images are not
copied.
Cause
Image density is too high. Adjust the image density. See "Adjust-
Auto Image Density is
not selected.
Image density is too high. Adjust the image density. See "Adjust-
Auto Image Density is
not selected.
Image density is too high. Adjust the image density. See "Adjust-
The exposure glass or
ADF is dirty.
The original that has al-
ready been printed is
scanned.
Image density is too light. Adjust the image density. See "Adjust-
A light copy may result
when you use damp or
rough grain paper.
Toner bottle is almost
empty.
The original is not set cor-
rectly.
The correct paper size is
not selected.
When You Cannot Make Clear Copies
Solution
ing Copy Image Density", Copy/Docu-
ment Server Reference.
Adjust the auto density. See "Adjusting
Copy Image Density", Copy/Docu-
ment Server Reference.
ing Copy Image Density", Copy/Docu-
ment Server Reference.
Adjust the auto density. See "Adjusting
Copy Image Density", Copy/Docu-
ment Server Reference.
ing Copy Image Density", Copy/Docu-
ment Server Reference.
Change the orientation of the original.
Put mending tape on the pasted part.
Clean them. See p.114 "Maintaining
Your Machine".
Select [Generation Copy], and then begin
copying. See "Generation Copy",
Copy/Document Server Reference.
ing Copy Image Density", Copy/Docu-
ment Server Reference.
Use the recommended paper. also, use
paper that has been stored in the rec-
ommended temperature and humidity
condition. See "Copy Paper", About
This Machine.
Contact your service representative.
Add toner. See p.87 "Adding Toner".
Set originals correctly. See "Placing
Originals", Copy/Document Server
Reference.
Select the proper paper size.
2
27