Omron SYSDRIVE 3G3EV SERIES User Manual page 36

c) n31 (electronic thermal reference current)
d) n11 (reference frequency)
Test Run:
Check motor operation.
Use the Digital Operator to check motor operation. Perform a no-load test run and an
actual loading test run to check the direction of motor rotation, speed, and output cur-
rent.
4. Setting the SYSMAC PC
Turn the Inverters, peripheral devices, and PC off, then turn them on. Turn on the
power in the following order:
a) SYSDRIVE and other Remote I/O Slave Units,
b) CPU for the Remote I/O Master Unit. Create an I/O table on the SYSMAC side. For
C1000H(F) or C2000(H), set the base no.
5. Production Run:
The Inverter is ready to run. If any error has occurred, refer to Section 5 Operation .
Chapter 4