Canon EOS 70D(W) Instruction Manual page 153

11: Connection target not found
In the case of [q], is EOS Remote running?
Establish a connection using EOS Remote (p.37, 78).
In the case of [l], is the power of the printer on?
Turn on the printer.
In the case of [D], is the pairing software running?
Start the pairing software and follow the instructions to re-establish
the connection (p.95).
Are the camera and the access point set to use the same
encryption key for authentication?
This error occurs if the encryption keys do not match when the
authentication method for encryption is set to [Open system].
The setting is case-sensitive, so check upper- and lower-case
characters. Make sure that the correct encryption key for
authentication is entered on the camera (p.69, 117).
12: Connection target not found
Is the power of the target device and access point on?
Turn on the target device and access point.
21: No address assigned by DHCP server
What to check on the camera
On the camera, IP address is set to [Auto assign]. Is this the
correct setting?
If no DHCP server is used, configure settings after setting the IP
address to [Manual setting] on the camera (p.59, 64, 70, 109, 113,
118).
What to check on the DHCP server
Is the power of the DHCP server on?
Turn on the DHCP server.
Are there enough addresses for assignment by the DHCP server?
Increase the number of addresses assigned by the DHCP server.
Remove devices assigned addresses by the DHCP server from
the network to reduce the number of addresses in use.
Responding to Error Messages
153