ZyXEL Communications U-336E User Manual page 62

Command
+FBOR=n
+FBUF?
+FCIG="string"
+FCLASS=n
+FCON
+FCQ=n
+FCR=n
+FDCC=vr,br,wd
,ln,df,ec,bf,st
50 Fax Operation
Value Description
Determine if Copy Quality OK on the
T.30 flow chart . <value>=0 to 255; a
value of 0 implies that error checking
is disabled.
Phase C data bit order:
n=0 Select direct bit order.
n=1 Select reversed bit order in receiving
mode for phase C data.
Buffer size; read only parameter:
Allow DTE to determine the
characteristics of the DCE's buffer
size.
Local fax station ID string, for polling
Rx.
Service class selection: Refer to
+FCLASS Class 1 command in
previous section.
DCE responds fax connection .
Copy quality check capability
parameter
n=0 No copy quality check capability.
n=1 Only check 1D phase C data.
n=2 Check both 1D and 2D phase C data.
"Capability to receive" parameter
n=0 DCE will not receive message data or
poll a remote device.
n=1 DCE receives message data or polls a
remote device.
DCE capabilities parameters.
vr=0 Vertical resolution: Normal; 98 lpi.
vr=1 Vertical resolution: Fine; 196 lpi.
br=0 Bit rate: 2400 bit/s; V.27ter.