ZyXEL Communications P-792H Quick Start Manual page 4

1. DSL: Use the provided telephone cable to connect the P-792H v2's
DSL port to a telephone jack.
2. ETHERNET: Use an Ethernet cable to connect a computer to the
ETHERNET port for initial configuration and/or Internet access.
3. POWER: Use the power adaptor provided with your P-792H v2 to
connect an appropriate power source to the POWER socket. Make
sure the power source is on.
4. Push in the POWER button. Look at the lights on the front panel.
• The POWER light blinks while your P-792H v2 starts up and stays
on once it is ready. The DSL LED blinks while the P-792H v2 is
trying to establish a connection with the ISP and stay on when the
connection is established. The INTERNET light is on when you are
able to access the Internet and blinks when the P-792H v2 is
sending or receiving data.
• The ETHERNET light stays on if the ETHERNET port is properly
connected and blinks when there is traffic.
If any of these lights are not on, check your connections, and inspect
your cables for damage. If the lights are still off, contact your local
vendor.
4