Setting The Bios Configuration Jumper Block; Location Of The Bios Configuration Jumper Block; Jumper Settings For The Bios Setup Program Modes (J9G1) - Intel D845HV Product Manual

Setting the BIOS Configuration Jumper Block

CAUTION
Always turn off the power and unplug the power cord from the computer before changing the
jumper. Moving the jumper with the power on may result in unreliable computer operation.
The location of the board's BIOS configuration jumper is shown in Figure 17.
Figure 17. Location of the BIOS Configuration Jumper Block
The three-pin BIOS jumper block enables all board configurations to be done in BIOS Setup.
Table 5 shows the jumper settings for the Setup program modes.
Table 5.

Jumper Settings for the BIOS Setup Program Modes (J9G1)

Function / Mode
Normal
Configure
Recovery
1
3
J9G1
Jumper Setting Configuration
1-2 The BIOS uses current configuration information and passwords
1
for booting.
3
2-3 After the POST runs, the BIOS displays the maintenance menu.
1
Use this menu to clear passwords.
3
None The BIOS attempts to recover the BIOS configuration. A
1
recovery diskette is required.
3
Installing and Replacing Desktop Board Components
OM11996
37