Dimplex BLF34 Owner's Manual page 12

Fireplace Installation
3. Hold the wall mounting brack-
et, with the bubble level on
the top, on the wall so that the
bubble on the level is centered
between the two black lines.
4. Mark the 3 mounting screw
locations, on the wall, ensur-
ing that the wall bracket stays
level. (Figure 5)
5. In locations where the screws
are being installed only into
drywall, install the supplied
wall anchors before installing
the screw (predrill if required).
6. Secure the wall bracket to the
wall using the supplied 1½ in.
(3.8 cm) mounting screws and
washers into the wall and/or
wall anchors.
7. Install the bottom support
bracket to the wall centered
Figure 7
2 x 4 Framing
12
with the wall mounting bracket,
using the appropriate mount-
ing hardware, 13 ¾" (350
mm) below the wall mounting
bracket. (Figure 5)
8. Remove the center back screw
from the bottom of the fire-
place. (Figure 6)
9. Hang the fireplace from the
bracket.
10. Install the removed screw
through the bottom support
bracket into the fireplace.
11. Refer to Front Glass Installa-
tion section, page 15 for final
installation procedures.
Figure 8
Mounting
holes
Mounting hole
www.dimplex.com