Table of Contents
Advertisement
PANEL & REMOTE CONTROL DESCRIPTION
1. PANEL & REMOTE CONTROL DESCRIPTION
1.1. FRONT PANEL DESCRIPTION
1
3
2
4
5
6
1. POWER: Switches the receiver on, or enters standby mode. To completely switch off the receiver,
you have to use the switch on the back of the receiver.
2. POWER LED: Indicates that the mains voltage (90-230 VAC) is available.
3. LOCK LED: Indicates a sufficient signal level at the IF IN input.
4. DISPLAY: 4 Digits to display the program numbers.
5. IR-SENSOR: Reception sensor for the IR remote control signals.
6. CH+/-: These buttons allow changing the current channel.
1
2
3
4
5
6
7
8
1. IF OUT: Satellite output for cascading to other devices.
Note: The operation of another receiver at the same time is only possible with limited channel selection.
2. IF IN: Satellite input.
3. S/PDIF: Coaxial output for digital audio (AC3).
4. RS-232: Serial Port allowing software upgrades.
5. AC IN: Mains input cable.
6. POWER ON/OFF: Allows to completely switching off the receiver.
7. TV SCART: Output SCART for the connection to a TV set.
8. VCR SCART: Output SCART for the connection to a VCR.
PAG.
12
Advertisement
Table of Contents
