Integra DTR-50.3 Instruction Manual page 39

Listening Mode Description
• Dolby Pro Logic IIz Height + THX Cinema
• Dolby Pro Logic IIz Height + THX Music
• Dolby Pro Logic IIz Height + THX Games
The combination of Dolby Pro Logic IIz Height and THX
Cinema/Music/Games modes can be used.
The PLIIz indicator lights on the display.
• DTS Neo:6 Cinema + THX Cinema
• DTS Neo:6 Music + THX Music
• DTS Neo:6 + THX Cinema
• DTS Neo:6 + THX Music
• DTS Neo:6 + THX Games
The combination of DTS Neo:6 and THX Cinema/Music/Games modes can
be used. The Neo:6 indicator lights on the display.
• THX Select2 Cinema
N e o T H X : S 2 6 C i n e m a
This mode expands 5.1-channel sources for 7.1- channel playback. It does
this by analyzing the composition of the surround source, optimizing the
T H X S 2 M u s i c ambient and directional sounds to produce the surround back channel
output.
• THX Select2 Music
T H X S 2 G a m e s
This mode is designed for use with music. It expands 5.1-channel sources
for 7.1-channel playback.
T H X S u r r E X
• THX Select2 Games
This mode is designed for use with video games. It can expand 5.1-channel
sources for 6.1/7.1-channel playback.
• THX Surround EX
This mode expands 5.1-channel sources for 6.1/7.1- channel playback. It's
especially suited to Dolby Digital EX sources. THX Surround EX, also
known as Dolby Digital Surround EX, is a joint development between
Dolby Laboratories and THX Ltd.
• Dolby Pro Logic II Game + THX Select2 Games
The combination of Dolby Pro Logic II Game and THX Select2 Games
modes can be used. The PLII indicator lights on the display.
Note
*1 Depending on the "Speaker Configuration" setting
surround back speakers by pressing SP Layout.
*2 Based on the audio channel signal contained in the source, the corresponding speakers will output the sound.
*3
If there are no surround back speakers, Dolby Pro Logic II is used.
*4 For the Blu-ray Discs, Dolby Digital is used in a 3.1/5.1-channel speaker system.
*5 AV receiver can input the DSD signal from HDMI IN. Setting the output setting on the player side to PCM might obtain a better
sound according to the player. In that case, set the output setting on the player side to PCM.
*6 If there are no surround back speakers, DTS is used.
*7
• This listening mode can be selected only when all the following conditions are satisfied:
– Center speaker is connected.
– Either of front high or front wide speakers is connected.
• Depending on the "Speaker Configuration" setting
wide speakers by pressing SP Layout.
• The listening modes cannot be selected with some source formats.
(➔ page 47), the output can be switched between the front high, front wide or
(➔ page 47), the output can be switched between the front high or front
Input Speaker
Source Layout
En
39