Learning Commands - Integra DTR-50.4 Instruction Manual

Learning Commands

The AV receiver's remote controller can learn the
commands of other remote controllers. By transmitting, for
example, the Play command from your CD player's remote
controller, the supplied remote controller can learn it and
then reproduce the exact same command when its
pressed in CD remote mode.
This is useful when some buttons don't work as expected
though you entered the appropriate remote control code
(➔ page 84).
Receiver
Remote
Mode
1 While holding down the Remote Mode button for
the mode in which you want to use the command,
press and hold down Receiver until the Remote
Mode button lights (about 3 seconds).
2
On the supplied remote controller, press the
button to which you want to assign the new
command.
3
Point the remote controllers at each other, within
about 4 inches (10 cm) apart, and then press and
hold the button whose command you want to
acquire until the Remote Mode button flashes.
If the command is learned successfully, the Remote
Mode button flashes twice.
Within about
is
4 inches (10 cm)
4
To learn more commands, repeat steps 2 and 3.
Press any Remote Mode button when you've
finished. The Remote Mode button flashes twice.
Note
• The following buttons cannot learn new commands: Receiver,
All Off, My Movie, My TV, My Music, Remote Mode,
Mode.
• The remote controller can learn approximately 70 to 90
commands, although this will be less if commands that use a lot
of memory are learned.
• Remote controller buttons such as Play, Stop, and Pause are
preprogrammed with commands for controlling Integra/Onkyo
CD players, cassette decks, and DVD players. However, they can
learn new commands, and you can restore the preprogrammed
commands at any time by resetting the remote controller
(➔ page 85).
• To overwrite a previously acquired command, repeat this
procedure.
• Depending on the remote controller used, some buttons may not
respond as expected, or the learning process itself may not be
possible.
• Only commands from infrared remote controllers can be
acquired.
• When the remote controller runs out of batteries, all commands
acquired will be lost and will have to be learned all over again.
Therefore, do not discard your other remote controllers.
En-88
■
Deleting Acquired Commands
1. While holding down the Remote Mode button for the
mode from which you want to delete a command, press
and hold down TV until the Remote Mode button
lights (about 3 seconds).
2. Press the Remote Mode button or the button from
which you want to delete the command.
The Remote Mode button flashes twice.
When you press the Remote Mode button, all
commands learned in that mode will be deleted.
Supplied remote
controller
Controlling Other Components